Logic Oscillator

Logic Oscillator

$100.00

The CPLLC Logic Oscillator steps through up to 10 settings on a timer.

SKU: CPLLC.SDK.Logic.Oscillator Categories: , ,

Description

The CPLLC Logic Oscillator steps through up to 10 settings on a timer. The installer gives each setting a name, an icon and a number of seconds. Start runs the first setting’s event and shows it on the tile; after its seconds the next setting takes over, and after the last one it goes back to the first, over and over until Stop. A sequence on each setting’s event decides what happens at that step, so the Oscillator can cycle lights, colors, scenes or anything else a sequence can do. Touching the tile starts and stops it. It is for logic only: it reads and drives no hardware by itself.

Drivers->Logic->Control Programming LLC->Oscillator (Latest Release Notes) (Download Latest Version)

Windows utility that simplifies sideloading of drivers and extensions.

Valid Crestron Home icon names are listed here. All icon names begin with the letters “ic”, for example “icStop” or “icPlay”.

This extension requires the License Manager to also be installed on the Crestron Home processor. It is found in Crestron Home at Drivers->License Manager->Control Programming LLC->License Manager.

All license purchases are final and non-refundable. Every CPLLC driver works fully for two hours without a key: test it on your processor before you buy. See the Terms of Use.

Installer Options

  • Obtain License Key – Opens CPLLC.net, where license keys and site licenses can be purchased.
  • Enter License Key – The Logic Oscillator license key. Leave blank when the site has a CPLLC site license.
  • Tile Icon – The tile’s icon while the Oscillator is stopped (default icStop), by its name in the Crestron Home icon library.
  • Page Header Text – The tile’s text before any setting has run (default Oscillator).
  • Setting 01 – 10 – One setting as name|icon|seconds: parameter 1 is the setting name, parameter 2 is the icon, parameter 3 is the seconds (e.g. Red|icRemoteButtonRed|10). Seconds may have decimals; a value below 1, or missing, is 1 second. Leave it blank when the setting is not used. Give each setting a different name: its event and Select Setting use it.

Actions

  • Start – Starts the Oscillator at the first setting. Does nothing when it is already running.
  • Stop – Stops the Oscillator. Does nothing when it is already stopped.
  • Select Setting – Runs the setting chosen from the list once, as the tile would show it, without starting, stopping or retiming the Oscillator.
  • Extension Enable / Extension Disable – Enables or disables the extension. Disabling stops a running Oscillator (Stopped runs) and shows Disabled on the tile; while disabled, touching the tile, Start and Stop do nothing. Enabling leaves it stopped.

Events

  • Pressed <name> – One for each setting named (Pressed Red, Pressed Green …): that setting has just started.
  • Started – The Oscillator started, from the tile or a sequence.
  • Stopped – The Oscillator stopped.
  • Extension Enabled / Extension Disabled – The extension was enabled or disabled.

Related products